Mercedes-Benz Validity These installation instructions

Validity These installation instructions are valid for vehicles equipped with a 1 • mobile phone fitting with interface (code 386) or • Mercedes-Benz mobile phone (code 388) Accessories Installation Instructions Mercedes-Benz Telephone Module with Bluetooth® wireless technology in combination with a Bluetooth®-capable mobile phone approved by Mercedes-Benz. Vehicles equipped with an infrared-reflec- ting windshield are not covered by these in- stallation instructions. Using the telephone module with mobile phones that have not been approved by Mer- cedes-Benz may lead to malfunctions. Parts included BluetoothR • (1) Mercedes-Benz telephone module with Bluetooth® Wireless Technology M+P-03F-6662 © 2007, Daimler AG 02/07 03F074-06 In the following text, this will be referred to as "telephone module". Notes Please contact a qualified specialist work- shop if you encounter difficulties when fit- ting the telephone module. Mercedes-Benz recommends that you use a Mercedes-Benz Service Centre for this purpose. The manufacturer reserves the right to change technical details from those shown in the illustrations contained in these instal- lation instructions. These installation instructions also refer to the COMAND and Audio Operating Instruc- tions, the vehicle Owner's Manual and the mobile phone operating instructions. Please keep these handy for reference. 2 3 Fitting the telephone module Contents Fitting the telephone module 4 Pairing and connecting • Requirements • General notes • Pairing procedure • Automatic connection • Manual connection Manufacturer-specific mobile phone features Disconnecting • Automatic disconnection • Manual disconnection Removing the telephone module 12 5 5 6 8 8 10 11 11 GRisk of accident Please comply with the legal regula- tions of the country in which you are driving when you use the mobile phone inside the vehicle. If it is legally permissible to use the mobile phone while driving, only do so when traffic conditions allow for it. You may otherwise become dis- tracted from the traffic, which may lead to an accident in which you or others may be injured. For safety reasons, while driving, only use the hands-free system to make calls. When you use the mobile phone via the hands-free system, drive with extra caution, close all windows, try to eliminate background noise and observe the traffic situation. Please pull over or park the car if you do not wish to use the hands- free system to make a call. Do not stop the vehicle or park where it is prohibited to do so. 2 1 M+P-03F-6663 1. Press the telephone module (1) onto the contact plate (2) until it engages.

11 Disconnecting the telephone module from the mobile phone Note During an active call, the connection bet- ween the mobile phone and the telephone module can only be disconnected on the mo- bile phone. (Please refer to the mobile phone operating instructions.) This procedure will not disconnect a call which is in progress. Automatic disconnection When the mobile phone is out of the telepho- ne module's range, the mobile phone is au- tomatically disconnected. Manual disconnection Valid for S-Class vehicles, model series 221, and CL-Class vehicles, model series 216: 1. Using the COMAND controller, select "Telephone" "Telephone off" and confirm. Valid for all other model series: 1. Press and hold the button for ap- prox. 3 seconds on COMAND or the audio system. Manually disconnecting the mobile pho- ne 1. (Please refer to the mobile phone opera- ting instructions.) Notes When the Bluetooth® connection has been manually disconnected, an automatic search is not performed when the key is in position 1 or 2 in the ignition. When within range, the Bluetooth® connec- tion remains active and any incoming calls are received on the hand-free system. There- fore, the connection between the mobile phone and the telephone module should be disconnected manually when you leave the vehicle.

Get The File :  Download here

Mercedes Benz C-Class Owner's Manual PDF

Owner's Manual C-Class Nur fuer internen Gebrauch * Optional equipment H Environmental note ! Possible vehicle damage E Instruction ee Continuation symbol ( e page) Page reference Display Display in the multi-function Nur fuer internen Gebrauch Thank you for choosing Mercedes- Benz. Before you drive off, familiarise yourself with your Mercedes-Benz and read the Owner's Manual. This will help you to ob- tain the maximum pleasure from your ve- hicle and to avoid endangering yourself Items of optional equipment are marked with an asterisk *. The equipment in your vehicle may vary, depending on the model, country specifications and availability. Mercedes-Benz is constantly updating its vehicles to the state of the art and there- fore reserves the right to introduce changes in design, equipment and techni- cal features at any time. You cannot, therefore, base any claims on the data, il- lustrations or descriptions in this Owner's The Owner's Manual, Brief Instructions and the Service Booklet belong with the vehicle. You should always keep them in the vehicle and pass them on to the new owner if you sell the vehicle. Please consult a Mercedes-Benz Service Centre if you have any questions. The technical documentation team at DaimlerChrysler AG wishes you safe and pleasant motoring. iYou can also get to know the major fea- tures of your C-Class in the interactive Owner's Manual on the Internet at: www.mercedes‑benz.de/betriebsanlei- tung

7 7G‑TRONIC . . . . . . . . . . . . . . . . . . . . . 114 A ABS . . . . . . . . . . . . . . . . . . . . . . . . . . . . 68 Display message . . . . . . . . . . . . . . 246 Display message (luxury multi- function steering wheel) . . . . . . . . 246 Display message (multi-function steering wheel) .......... 226, 228 Warning lamp . . . . . . . . . . . . . . . . 259 Acceleration Technical data . . . . . . . . . . . . . . . . 319 Accident Notes . . . . . . . . . . . . . . . . . . . . . . 267 Active Light System . . . . . . . . . . . . . 102 Adaptive brake lamps . . . . . . . . . . . . 68 Additional speedometer Activating/deactivating (on- board computer, luxury multi- function steering wheel) . . . . . . . . 136 Additional turn signal (exterior mirrors) . . . . . . . . . . . . . . . . . . . . . . . 285 ADVANCED AGILITY package with sports mode . . . . . . . . . . . . . . . 147 ADVANCED AGILITY package with sporty driving mode Indicator lamp . . . . . . . . . . . . . . . . 257

Get The File :  Download here

Mercedes-Benz Accessories Installation Instructions Manual with Bluetooth® wireless technology

1 Accessories Installation Instructions Mercedes-Benz Cradle adaptor with Bluetooth® wireless technology M+P-03F-6311 The Mercedes-Benz approved/recom- mended Bluetooth® Phones can be utilized inside Mercedes-Benz vehicles. Application These installation instructions are valid for vehicles with an MHI hands-free communi- cations systems and a Mercedes-Benz-ap- proved Bluetooth® mobile telephone. Approved mobile telephones are listed and can be purchased on the Internet at www.wireless4mb.com or call 1-800-266- 7746 to speak to a wireless activation specialist. Parts included • (1) Mercedes-Benz Cradle adaptor with Bluetooth® wireless technology GWarning It is not recommended to operate the mobile telephone keypad while driving. Notes Please contact your local Mercedes-Benz Center if you encounter difficulties when operating the Mercedes-Benz Hands-Free Communication System. More information can be found on the Internet at www.wireless4mb.com or call 1-800-266-7746 to speak to a wireless activation specialist. © 2007, Daimler AG 10/07 03F029-05 2 3 4 6 8 3 4 Contents Installing the Mercedes-Benz Cradle adaptor with Bluetooth® Pairing the mobile telephone with the Mercedes-Benz Cradle adaptor with Bluetooth® Establishing a Bluetooth® Connection Connecting the mobile telepho- ne and Mercedes-Benz Cradle adaptor with Bluetooth® manually Disconnecting the Bluetooth® connection automatically Disconnecting the Bluetooth®- connection manually Detaching the Mercedes-Benz Cradle adaptor with Bluetooth® Pairing the mobile telephone with the Mercedes-Benz Cradle adaptor with Bluetooth® Make sure that the starter switch is in position 1, 2 or 3 (see the vehicle Operator's Manual). 3 9 9 10 Notes The manufacturer reserves the right to change technical details from those shown in the illustrations contained in these installation instructions. These installation instructions also refer to the vehicle Operator's Manual, COMAND Operator's Manual, and mobile telephone manual. Please refer to them for reference. Use of a mobile telephone other than a Mercedes-Benz approved/recommended model may result in improper performance and cannot be equipped or serviced by Mercedes-Benz. Installing the Mercedes-Benz Cradle adaptor with Bluetooth® 4 M+P-03F-6313 2 1 M+P-03F-6312 Insert the Mercedes-Benz Cradle adaptor with Bluetooth® (1) into the latches on the pre-installed contact plate (2), located in the center console. To insert the Mercedes-Benz Cradle adaptor with Bluetooth® (1), slide it upwards until it clicks into place. 1. With Mercedes-Benz Cradle adaptor with Bluetooth® connected to the vehicle press button (3) for approx. 2-3 seconds. The LED’s (4) will begin to flash rapidly. The Mercedes-Benz Cradle adaptor with Blue- tooth® is in Discovery Mode and can be detected by a Bluetooth® mobile telephone. The Mercedes-Benz Cradle adaptor with Bluetooth® will appear as "MB PhoneSys- tem" on the mobile telephone. 2. For instructions on how to get the mobile telephone ready for pairing, see the mobile telephone manual or visit www.wireless4mb.com. Once the mobile telephone and Mercedes-Benz Cradle adap- tor with Bluetooth® find each other the mobile telephone will prompt the user to enter a Pass-Key.

5 6 M+P-03F-6379 3. To locate the Pass-Key remove cover (5) by sliding it away from the Mercedes-Benz Cradle adaptor with Bluetooth®. Located behind this cover (5) there will be a sticker containing the Pass-Key (6). 4. When prompted, enter the Pass-Key into the mobile telephone. Depending on the type of mobile telephone being used, it may be necessary to confirm a connection request (see the mobile telephone manual). 5. Once the Pass-Key has been entered and accepted the LED’s (4) will be lit conti- nuously. This confirms that the mobile tele- phone is paired and connected and the mobile telephone information has been stored in the Mercedes-Benz Cradle adaptor with Bluetooth®. 6. The mobile telephone is now ready for use with the Mercedes-Benz Hands-Free Communication System.

Get The File :  Download here

Mercedes-Benz Vehicle Communication Software Manual PDF

Mercedes-Benz Vehicle Communication Software Manual August 2013 EAZ0025B41D Rev. A Trademarks Acknowledgements Snap-on is a trademark of Snap-on Incorporated. All other marks are trademarks of their respective holders. Copyright Information ©2013 Snap-on Incorporated All rights reserved. Disclaimer The information, specifications and illustrations in this manual are based on the latest information available at the time of printing. Snap-on reserves the right to make changes at any time without notice. Visit our Web site at: http://diagnostics.snapon.com For Technical Assistance Call: 1-800-424-7226 ii Safety Information For your own safety and the safety of others, and to prevent damage to the equipment and vehicles upon which it is used, it is important that the accompanying Safety Information be read and understood by all persons operating, or coming into contact with, the equipment. We suggest you store a copy near the unit in sight of the operator This product is intended for use by properly trained and skilled professional automotive technicians. The safety messages presented throughout this manual are reminders to the operator to exercise extreme care when using this test instrument. There are many variations in procedures, techniques, tools, and parts for servicing vehicles, as well as in the skill of the individual doing the work. Because of the vast number of test applications and variations in the products that can be tested with this instrument, we cannot possibly anticipate or provide advice or safety messages to cover every situation. It is the automotive technician’s responsibility to be knowledgeable of the system being tested. It is essential to use proper service methods and test procedures. It is important to perform tests in an appropriate and acceptable manner that does not endanger your safety, the safety of others in the work area, the equipment being used, or the vehicle being tested. It is assumed that the operator has a thorough understanding of vehicle systems before using this product. Understanding of these system principles and operating theories is necessary for competent, safe and accurate use of this instrument. Before using the equipment, always refer to and follow the safety messages and applicable test procedures provided by the manufacturer of the vehicle or equipment being tested. Use the equipment only as described in this manual. Read, understand and follow all safety messages and instructions in this manual, the accompanying safety manual, and on the test equipment.

Safety Information ..................................................................................................................... iii Contents ...................................................................................................................................... v Chapter 1: Using This Manual ................................................................................................... 1 Conventions.................................................................................................................................. 1 Bold Text................................................................................................................................ 1 Terminology ........................................................................................................................... 1 Notes and Important Messages.................................................................................................... 2 Notes...................................................................................................................................... 2 Important................................................................................................................................ 2 Chapter 2: Introduction.............................................................................................................. 3 Chapter 3: Operations................................................................................................................ 4 Identifying the Vehicle .................................................................................................................. 4 Selecting a System....................................................................................................................... 6 Connecting to a Vehicle................................................................................................................ 6 Selecting a Test.......................................................................................................................... 11 Main Menu Selections ................................................................................................................ 11 Codes................................................................................................................................... 11 Data ..................................................................................................................................... 11 Functional Tests................................................................................................................... 12 Review ECU ID .................................................................................................................... 13 Stop Communication............................................................................................................ 13 Scanner Demonstration Program ............................................................................................... 13

Get The File :  Download here